RobotGuide
Labs/Hertz Contact Calibration Bench

Lab 11 / 15 · Interactive · real-time

Hertz Contact Calibration Bench

Drag indentation depth and material: see why force goes as depth to the 1.5 power and stiffness grows as you press harder.

Math: Power functionsNo coding neededNo hardware needed≈ 6 min

Contact parameters

Indentation δ1.00 mm
Ball radius R8 mm
Effective modulus E*0.30 MPa

What to look at

Quadruple the indentation and the force goes up 8x — 4 to the power of 1.5. The highlighted arc is the true contact area, growing with indentation.

Dimensionless framing: real silicone fingertips deviate from this curve at large depths (large deformation + adhesion). Hertz gives the baseline before the first correction term kicks in.

What problem this lab solves

«The deeper you press, the harder it feels» — not because the material hardened, but because the contact circle is growing: a² = Rδ, so load-bearing area grows linearly with depth. That geometric mechanism is the physical foundation of every tactile sensor's calibration curve and of soft-fingertip grasping — and it is the visualization of T11's F ∝ δ^1.5.

How to read the figure

Left is the cross-section: a sphere pressed into a plane, with the true contact arc highlighted (note how it grows with depth). Right is the pressure distribution p(r) on the contact surface — an elliptical profile that falls to zero at the edge. Watch three numbers: contact radius a, total force F, contact stiffness k = dF/dδ. Double the depth: a grows only √2×, but F grows 2.83×.

Hands-on

Drag depth from 0.5 mm to 2 mm (4×) and record how many times F grows (answer: 8× — 4 to the 1.5). Then halve the modulus E* and watch what happens to F and a (force halves, contact grows √2× — a softer material carries the same relative load over more area).

Related topics

Next labs (in play-learn order)