RobotGuide

Eight pitfalls

These mistakes are not in the tutorials, because tutorial authors do not write about their own scars. Each one comes with the correct practice.

  1. Learning ROS before the fundamentals

    ROS 2 is just a glue layer. Without C++, control, and kinematics fundamentals, all you'll do after learning it is drag a cube around. The right order: language → math → robotics → ROS.

  2. Only reproducing tutorials

    TurtleBot mapping and navigation, MoveIt grasping — resumes are full of them, zero differentiation. Do 'modification' and 'failure analysis' instead.

  3. Believing the 'full-stack' label

    Robotics full stack spans five disciplines — mechanical, electronic, control, AI, software — and a true full-stack person barely exists. Writing 'full-stack' on a resume exposes your weakness in an interview.

  4. Spending thousands on training courses

    Every core resource in this field is free and open source. Spend the money on dev boards and sensors, not courses.

  5. Thinking algorithm roles are the only way out

    Algorithm roles are the most competitive with the highest degree barriers. System software, motor control, and integration tracks are short-staffed and stable, often better value.

  6. Only watching keynotes and social media

    Many takes write 'layered' and 'end-to-end' as opposites when they are two descriptions of the same thing. Read official docs and open-source code.

  7. Ignoring real-time performance and jitter

    'Average latency 1ms' means almost nothing in robotics; 'jitter 50µs' is what's valuable. This one line separates toys from products.

  8. Talking feelings instead of measuring data

    When the interviewer asks 'how do you guarantee the 1kHz loop doesn't jitter', the only convincing answer is a measured curve, not adjectives.

  9. Calling it done when the board runs

    Between 'it blinks an LED' and 'it's a product' lie four gates: power, return paths, EMC, protection. A board without test points can only be debugged by guesswork, and one revision costs two weeks.

  10. Powering on right after soldering

    First measure power-to-ground resistance, then power up in stages from 100 mA with a current-limited supply. One puff of smoke can take out a row of chips and two weeks of your time.

  11. Using USB or Ethernet for 1kHz control

    Their scheduling jitter is millisecond-level — physically impossible for this. Real-time control either goes EtherCAT or sinks the loop into an MCU.