RobotGuide
Hardware selection/Boards, Instruments, and Tools

Selection 4 / 5

Boards, Instruments, and Tools

Buy what lets you measure first, then what lets you build

This table is ordered by when you must buy. The two most argued-over items are the oscilloscope and the logic analyzer: they will not let you build things, but they decide whether you can debug them.

PriorityItemPriceWhen to buyWhat happens without it
Must buyMultimeter¥100–400Day oneYou never know whether the voltage is right; every check is a guess
Must buyBench power supply (30 V / 5 A, current-limited)¥200–600Day oneBoards burn on power-up and you never know why
Must buyJumper wires / terminals / perfboard¥50–150Day oneYou cannot connect things, or connections do not hold
RecommendedLogic analyzer (8 channels, entry-level)¥100–400When debugging I2C / SPI / UARTYou can only confirm there is a signal, not its content or timing
RecommendedOscilloscope (100 MHz, 2 channels)¥1500–3000When debugging PWM / current / noiseYou cannot see dead zones, spikes, or ground bounce — the three regulars of electronics failures
RecommendedSoldering iron + hot-air gun¥300–800When you need to rework boards / replace chipsYou can only buy ready-made modules and cannot modify them
RecommendedUSB-CAN analyzer¥150–400When debugging joint busesCAN errors stay guesswork; you cannot see arbitration or error frames
Not urgentCurrent probe¥800+When measuring µs-level current waveformsStart with a shunt resistor + differential probe instead
Not urgentSpectrum analyzer¥3000+When doing EMC fixesBorrow one, or send the unit out for testing

Quick picks for three scenarios

Budget under ¥1,000

Multimeter + bench power supply + logic analyzer

These three cover 80% of the 'why does nothing work' questions

Budget ¥3,000

Add an entry-level oscilloscope

You upgrade from 'is there a signal' to 'what the signal looks like'

Do not want to buy instruments

At least buy a USB power meter

Spotting abnormal current already rules out half the problems

Three easy-to-miss points