RobotGuide
Hardware selection/Motor and Transmission

Selection 2 / 5

Motor and Transmission

First compute the end-effector torque, then work back to the motor

Motor selection always works backward: how heavy and how fast the end effector must move → how much joint torque and speed is needed → divide by the gear ratio → only then pick a motor. Choosing in the other order always ends up too big or too small.

OptionTorque densityBacklashPriceGood forPitfalls
Brushed DC + planetaryLowLarge (1–3°)¥30–150Teaching carts, prototypesShort brush life; burns out when stalled
Stepper + timing beltMedium (large holding torque at rest)Medium¥80–3003D printing, light-load positioningLoses steps at high speed, unknowable without feedback
BLDC + FOC + planetaryHighMedium¥300–1500Quadrupeds, arm joints, gimbalsNeeds a driver and current-loop tuning
BLDC + harmonic driveHighNear zero¥3000–15000Collaborative arms, humanoid jointsFragile under shock; overload causes permanent damage
Servo + RV reducerVery highSmall¥3000+Industrial arms, heavy loadsHeavy, expensive, needs a dedicated drive
Linear motor / electric actuatorHigh (linear)None¥500–5000Linear motion, grippersLimited stroke, hard to protect

Quick picks for three scenarios

End effector lifts 2 kg at 0.5 m arm length

End torque ≥ 10 N·m → BLDC 1 N·m + harmonic i=50

Leave 1.5x margin for acceleration and impact

Quadruped single-leg peak

BLDC + planetary i≈9

A small gear ratio means small reflected inertia and fast response; this is the key difference between quadrupeds and cobots

Positioning only, no force control

A stepper is enough

Saves money and hassle, but know that it loses steps

Three easy-to-miss points