Lab 8 / 15 · Signals · A/B
Differential Signaling and the Eye Diagram
Drag bit rate, cable length, and termination, and watch the eye go from open to shut.
Link parameters
The 'open' termination option equals no resistor installed — the most common mistake in the field.
Readouts
The model covers rise time, one reflection, and Gaussian noise only — no full frequency response or ISI. Magnitudes reference real links but do not replace a measured eye diagram.
What problem this lab solves
The most counterintuitive fact of signal integrity: the same wire runs 10 Mbps with zero trouble, and 480 Mbps with errors everywhere. The cause is not «the wire got worse» — it is that rise time's share of the bit period changed. This experiment turns the abstract «eye diagram» into something you can drag.
How to read the figure
Each trace is one combination of two or three bits; stacked together, the empty region in the middle is the «eye». The wider the eye, the bigger the decision margin; once it closes, bit error rate climbs exponentially. Vertical margin gets eaten by rise time and reflections; horizontal margin gets eaten by jitter.
Hands-on
Set termination to 120 Ω and length to 0.5 m — see how wide the eye opens. Then stretch the line to 10 m and watch it collapse. Next try 60 Ω and open (no termination), and feel why «impedance mismatch» is deadlier than «the line is too long».
Done playing — where next
Related topics
Next labs (in play-learn order)
Gear Ratio to End-Effector Force
Motor gives 3 N·m; through a 100:1 reduction, how much can the end effector actually push.
4 min
PWM and Current Ripple
Change frequency, duty cycle, and inductance, and watch the ripple — higher frequency is not automatically better.
7 min
Two-Link IK and Singularities
Drag the target point: watch two solution sets, and what happens the instant the arm goes straight.
7 min