Lab 6 / 15 · Calculator
Gear Ratio to End-Effector Force
Motor gives 3 N·m; through a 100:1 reduction, how much can the end effector actually push.
Sizing parameters
Referred to the end effector
Ignores gearbox efficiency (a default 85% is already included) and friction — for order-of-magnitude estimates. Real selection also weighs peak torque, thermal, and backlash.
What problem this lab solves
When mechanical and controls engineers argue, eight times out of ten it is over this conversion. Same motor, gear ratio from 50 to 100: end force doubles, speed halves, and backlash and reflected inertia change with it. Selection is not «bigger is better».
How to read the figure
Top is the motor-side torque-speed curve; bottom is the force and speed reflected to the end effector. Watch three numbers: sustained end force, max end speed, reflected inertia. Bigger ratio means more force and less speed, but inertia scales with the square — that is why high-ratio arms respond sluggishly.
Hands-on
Stretch arm length from 0.4m to 0.8m and watch end force fall (torque ÷ length, linear). Then tune the gear ratio to find the band where «force is enough and speed doesn't collapse». That is what selection actually looks like.
Done playing — where next
Related topics
Next labs (in play-learn order)
Two-Link IK and Singularities
Drag the target point: watch two solution sets, and what happens the instant the arm goes straight.
7 min
Differential Signaling and the Eye Diagram
Drag bit rate, cable length, and termination, and watch the eye go from open to shut.
9 min
What a Kalman Filter Actually Does
How a noisy sensor reading becomes an estimate that is smooth without lagging behind.
6 min